First baby steps in weaving

My first weaving project on the Tia rigid heddle loom

The Tia loom is warped and I'm weaving.  Yikes!

The above pic is the loom with the warp wound on the back.  The loops from the direct warping haven't yet been cut, meaning that the yarn is doubled in the slits but nothing is in the holes.

The above pic shows the warp fully sleyed through the heddle and tied onto the front.  I didn't bother with a surgeon's knot, just a plain bow knot of the sort used to tie shoes.  I did 8 threads per bundle since that's about an inch.  The last bits of that skein of Sugar n Cream were just sitting there, so I ran it through the base of the warp to help start spreading things out more evenly, and also to double-check that things were more or less doing what they ought to in terms of what threads were where, did the heddle do anything useful, was the tension more or less OK, and stuff like that.

And here's the first bits of weaving I've done as well as the first weaving I've done on this loom.  The angle of the pic is funny so not all the details are visible or the perspective is weird, that sort of thing.

The red cotton is a little thinner than the white.  So although the weave looks balanced and seems to be pretty close to balanced when I measure the picks per inch, when I look more closely it's slightly warp-faced.  Every now and then I don't quite pack it evenly, so there will be a little stripe of white or red.  Eh, I don't care.  I'll see how it looks when off the loom and finished.  It seems awfully gauzy for now, but I'm under the impression that's kind of normal.

It's taking a few inches for me to figure out how tight to keep things so the selvedges look OK, not too loose and not too tight.  In spite of that, the edges are really surprisingly straight, not pulling in or anything.  I'm sure they aren't professional grade or anything, but for beginner edges, they're not too bad.

In the first few picks, I sometimes improperly skipped over or under a warp thread.  Hopefully I can keep better track of this so I can fix problems quickly.  For the very beginning of the cloth, where the warp is still finding its happy spacing, I don't really care.

It looks a bit different depending on the angle -- more red or more white, depending.

I'm not sure how tight a tension this loom will hold.  But it seems OK.  It's not uber-tight tension but the warp doesn't seem to be loosening as I weave or anything.

Yay.  I'll keep weaving and will no doubt learn more things as I continue with this first project.

----------------------

Sweater project

I was swatching for the upcoming sweater today.  Last time I knit with the fuzzy gray handspun, I got 4.5 st/in on 3.25mm needles.  Today, I'm getting 4 st/in on 3mm needles.  Sigh.  The fabric seems fine, not too loose nor uber-stiff.  If I go down too much more in needle size, the stitches all start splitting and being difficult.  Also, I need to have enough different needle lengths for both the sweater body and the ribbing.

So.  Maybe this particular ball is a little thicker than some of the others, and the real gauge over several skeins of yarn ends up averaging about 4.5 st/in.  Or the fuzzy yarn fills in the spaces, the way mohair does, and it's really effectively closer to worsted weight yarn.  Or I'm just knitting more loosely these days.  Or I'm using a different tape measure that doesn't match the tape measure I used earlier, and my gauge is really the same.

Also, gauge swatches always lie.  Maybe they don't for some people, but I don't have a good track record of getting them to match the garment gauge even though I don't think I'm doing anything different when I make the gauge swatch.

I'll probably cast on a likely number of stitches and get started.  The lower part of the sweater will be my gauge swatch.  I'm not bothered by knitting and then unraveling a few thousand stitches if I don't like how it's going.  Depending on the real gauge vs the swatch gauge, I can do some discreet increases or decreases.  Or I can make this for someone else -- I know a few people who'd be delighted to have one of my handknit sweaters.

Lavori 07/30

It's time to test my potential chart fix.  I want to be making progress on this doily!

F&F Travel Shawl

Growing nicely.  I'm on the second ball of yarn, and doing 3 sets of feather and fan on each half of the shawl.  It is still a very reasonable combination of yarn, pattern, needle size, etc.

Spinning

Nothing new has been started yet.